Rockwell Automation 6181 Industrial Computer - Manual (Page 62)

6–4 Installing/Removing the Hard Drive, Floppy Drive, or Expansion Bay
Publication 6181-UM001D-EN-P
Replacing the floppy drive in the hard drive bay:
1. Perform the steps to disconnect and remove the hard drive bay on
Page 6-2.
2. Remove the four floppy drive mounting screws, loosen the hard
drive mounting screws, and slide the drive from the drive bay.
Note: The floppy drive and hard drive screws require different
tool bits.
3. Insert the floppy drive into the drive bay and secure the drive to the
bay with the four mounting screws. Tighten all eight mounting
screws to a torque of 0.7 to 0.9 N-m (6-8 in-lbs).
4. Replace the drive bay using the instructions on Page 6-3.