Rockwell Automation 2300 Family of Drive Systems Hardware - Manual (Page 15)

1-3
2. Remove the four end-cover plates, if present, from the sides of MCCs
that will be joined to other MCCs. Unfasten the 4 screws that secure
each plate. This will expose joining holes. See
Figure 1.2.
Figure 1.2 Removing the End Covers and Power Bus Plate
3. Remove the power-bus plates, if present, from the sides of MCCs that
will be adjacent to other MCCs. To remove a power bus plate, unfasten
10 screws. Refer to Figure 1.2.
Upper
End Covers
Power Bus
Plate
Lower
End Covers
Side View (R.H.)