Rockwell Automation 2300 Family of Drive Systems Hardware - Manual (Page 54)

5-14
Installing Offset Control Bus Splices
Use this procedure if bus ends are offset in depth:
1. Verify that the following splice hardware is present:
2. Slide one lock washer and one flat washer onto one screw.
3. Repeat 2 once.
4. Position one offset control busbar splice in front of the discontinuity in
the upper control bus. Reference Figure 5.8.
Figure 5.8 Installing an Offset Control Bus Splice
5. Align the two elongated holes of the offset control busbar splice over the
two holes bordering the discontinuity in the upper control bus.
6. Fasten the offset control busbar splice to the upper control bus, from the
front, using the same two screws.
7. Torque screws to 108 lb-in (12.2 N-m)
8. Repeat 2 through 7 to splice together the lower control bus.
Description Quantity
2-hole, offset busbar splice 2
1/4-20 x 3/4” hex-head screw 4
Flat washer 4
Lockwasher 4
Flat Washer
Hex-Head Screw
Lock washer
Straight Control
Bus Splice
L1
N
120 V AC
Threaded
Insert