Rockwell Automation 2300 Family of Drive Systems Hardware User Manual
Page 51
Advertising
5-11
Figure 5.6 Installing a Dual Bar Offset Power Bus Splice
4. Position one busbar splice as shown in Figure 5.6.
5. Slide one flat washer and one nut/conical-spring washer over the end of
each bus-clamp screw.
6. Torque all bus clamps to 38 lb-ft ± 2 lb-ft (52 N-m ± 3 N-m).
Busbar
Flat Washer
Splice Bars
Bus Clamp
One-Piece Nut and Conical Washer
Busbar
(Back)
(Front View)
Advertising