Chapter 3, Removing and installing roll-out chassis units, Introduction – Rockwell Automation 2300 Family of Drive Systems Hardware User Manual
Page 33: Before you begin, Introduction -1 before you begin -1
Advertising
Chapter
3
Removing and Installing Roll-Out Chassis Units
Introduction
This chapter provides the necessary steps to remove and install
roll-out chassis units.
Before You Begin
Before you begin installation, be sure you have the following:
• Tool(s) you will need to:
– disconnect and connect wires
– remove and tighten screws:
#10 thread-forming hexhead screw (0.312” across flats)
¼” thread-forming screw (0.375” across flats)
– remove and tighten bolts:
3/8” bolt (0.563” across flats)–for D/F-frame 2362 units
and K-code 2364F units
M10 bolt (17 mm across flats)–for G-frame 2362 units
and M/N-code 2364F units
• A means to remove the roll-out chassis unit
Advertising