Rockwell Automation 2300 Family of Drive Systems Hardware - Manual (Page 28)

2-2
Removal Procedure Follow the procedure below to remove bucket units from an MCC:
1. Open the door of the MCC.
Note: Removal of the door is not necessary.
2.
3.
Figure 2.1 Screwlatch Locations
!
ATTENTION: To avoid the hazard of electrical shock, verify
that all voltages on the system bus network have been discharged
before attempting to service the system.
If: Then:
You want to remove the door Follow the door removal procedure in
Chapter 4.
If: Then:
The unit to be removed is less than 2
space factors Disengage the screwlatches at the front of the
bucket unit – one at the top and one at the
bottom. See Figure 2.1.
Otherwise Disengage the screwlatches at the front of the
bucket unit – two at the top and one at the
bottom. See Figure 2.1.
Screwlatch
Screwlatch