Rockwell Automation 2300 Family of Drive Systems Hardware - Manual (Page 32)

2-6
4. Connect customer wiring at the bottom of the bucket, as appropriate.
5. Connect all wires that connect the module to stationary devices in the
MCC.
6.
7. If the door has been removed, follow the door installation procedure
found in Chapter 4.
If: Then
The unit to be removed is less than 2
space factors Engage the screwlatches at the front of the
bucket unit – one at the top and one at the
bottom. See Figure 2.1.
Otherwise Engage the screwlatches at the front of the
bucket unit – two at the top and one at the
bottom. See Figure 2.1.