Rockwell Automation 2300 Family of Drive Systems Hardware - Manual (Page 35)

Removing and Installing Roll-Out Chassis Units 3-3
5. If the sealing angle (shown in Figure 3.2) obstructs the roll-out chassis
from rolling out, remove the sealing angle.
6. For G-frame 2362 units and M or N-code 2364F units, remove the lower
brace, which is shown in Figure 3.2.
7. Remove both of the lower mounting angles, as shown in
Figure 3.2, by unfastening four screws each (used in D, E, and
F-frame 2362 units, and in K and L-code 2364F units).
Figure 3.2 Typical Mounting Hardware By Unit
Reinforcing
Sealing
Angle
Mounting
Angle (Typ. 2)
Angle (Typ. 2)
Upper
Mounting
Bracket
D-frame 2362 or
K-code 2364F
E-frame 2362, F-frame 2362
or L-code 2364F
G-frame 2362, M-code 2364F,
Upper
Mounting
Bracket
Lower
Brace
or N-code 2364F
Reinforcing
Angle
Mounting
Angle
3-Dimensional View