Rockwell Automation 2300 Family of Drive Systems Hardware User Manual
Page 53
5-13
Installing Straight Control Bus Splices
Use this procedure if bus ends are at the same depth:
1. Verify that the following splice hardware is present:
2. Slide one lock washer and one flat washer onto a screw.
3. Repeat 2 once.
4. Position one busbar splice in front of the discontinuity in the upper
control bus. Reference Figure 5.7.
Figure 5.7 Installing a Straight Control Bus Splice
5. Align the two elongated hoes of the straight control busbar splice over
the two holes bordering the discontinuity in the upper control bus.
6. Fasten the straight control busbar splice to the upper control bus, from
the front, using the same two hex head screws.
7. Torque both hex head screws to 108 lb-in (12.2 N-m).
8. Repeat 2 through 7 to splice together the lower control bus.
Description
Quantity
2-hole, straight busbar splice
2
1/4-20 x 3/4” hex-head screw
4
Flat washer
4
Lockwasher
4
Flat Washer
Hex-Head Screw
Lock washer
Straight Control
Bus Splice
L1
N
120 V AC
Threaded
Insert