Rockwell Automation 2300 Family of Drive Systems Hardware - Manual (Page 49)

5-9
Figure 5.5 Installing a Single Bar Offset Power Bus Splice
5. Position one busbar splice as shown in Figure 5.5.
6. Slide one flat washer and one nut/conical-spring washer over the end of
each bus-clamp screw.
7. Torque all bus clamps to 38 lb-ft ± 2 lb-ft (52 N-m ± 3 N-m).
Busbar
Flat Washer
Splice Bar
Bus Clamp
One-Piece Nut and Conical Washer Busbar
(Back)
(Front View)