Rockwell Automation 2300 Family of Drive Systems Hardware User Manual
Page 45
Advertising
5-5
2. Verify that contact surfaces are free of dirt/debris. Deburr edges as
necessary.
3. Insert the bus clamps, from the backside, through the holes at the ends of
the busses to be joined. Refer to Figure 5.3.
Note: Bus clamps will only fit into the busbar holes in the vertical
orientation.
Figure 5.3 Installing a Straight Power Bus Splice, Single Bar
4. Slide one busbar splice over the ends of the bus clamps as shown in
5. Slide one flat washer and one nut/conical-spring washer over the end of
each bus-clamp screw.
6. Torque all bus clamps to 38 lb-ft ± 2 lb-ft (52 N-m ± 3 N-m).
Power Bus
Bus Clamp
One-Piece Nut and Conical Washer
Flat Washer
Splice Bar
(Back)
(Front View)
Advertising