Rockwell Automation 57C329 Remote I/O Communications, AutoMax - Manual (Page 129)

KĆ11
1
2
3
4
DATA Ć VIOLET WIRE
DATA Ć BLACK WIRE
NO CONNECTION
NO CONNECTION
ADAPTER
TERMINAL CONNECTION
Figure K2.4 Ć RackĆMounted Transceiver Terminal Block Connections
Jumper
21 21 21 21
Rack Containing Four Transceivers
Terminal Strip
Figure K2.5 Ć Connecting RackĆMounted Transceivers to a Terminal Strip
Step 5. Connect each transceiver to the fiberĆoptic network using
the guidelines provided in section K2.5.
Step 6. Verify that the external power supply is turned off.
Connect the power cord to a 115 or 230VAC external
power supply. Note that the rack frame is grounded
directly through the ground pin of the line cord.
Step 7. Use the rocker switch on the front of the Power Supply to
turn power ON to the rack. A builtĆin indicator in the
switch will illuminate signifying the presence of power.
Step 8. Secure each transceiver with the captive screws on the
faceplate of the module. Attach the transparent plastic
front panel.
K2.4 Installing the FiberĆOptic Cable
The fiberĆoptic cable must be handled by experienced personnel
prior to and during installation. Improper handling may result in
damage to the cable. Unless you have inĆhouse expertise with
fiberĆoptic cable assemblies and installation, Reliance Electric
recommends that you contact an experienced contractor for making
up and installing fiberĆoptic cables. Use the following general
guidelines to protect the cable:
D Visually inspect the cable before the installation.