K2.6 replacing the standćalone transceiver, K2.7 replacing the rackćmounted transceiver – Rockwell Automation 57C329 Remote I/O Communications, AutoMax User Manual
Page 132
KĆ14
LEDs
ST
Connector
Pin
Pins
RT
Slot
Transceiver
Figure K2.6 Ć FiberĆOptic Ports and Connectors
K2.6
Replacing the StandĆAlone Transceiver
Use the following procedure to replace a StandĆAlone Transceiver.
Step 1.
Remove power from the external power supply that is
supplying power to this transceiver.
Step 2.
Disconnect the input power cable and the drop cable
from the transceiver's sixĆscrew terminal block.
Step 3.
Disconnect the fiberĆoptic cable from the transceiver.
Step 4.
Replace the transceiver.
Step 5.
ReĆconnect the input power cable and the drop cable as
shown in section K2.2. Connect the jumper between
terminals 3 and 4.
Step 6.
ReĆconnect the fiberĆoptic cable as shown in section
K2.5.
Step 7.
Turn power on to the external power supply.
K2.7
Replacing the RackĆMounted Transceiver
Use the following procedure to replace a RackĆMounted Transceiver.
Step 1.
Remove the plastic panel from the front of the FiberĆOptic
Rack.
Step 2.
Turn the FiberĆOptic Rack's Power Supply off using the
rocker switchon the Power Supply's faceplate.
Step 3.
Disconnect the fiberĆoptic cable from the transceiver.