Rockwell Automation 57C329 Remote I/O Communications, AutoMax - Manual (Page 27)

3Ć1
3.0 INSTALLATION
This section describes how to plan, construct, and install the Remote
I/O network coaxial cable system. This section also provides
instructions on how to install the Remote I/O module, the Shark
Interface module, the Remote I/O Heads, and the Remote Drive
Interface Head. Instructions are also provided on how to connect
them to the Remote I/O network.
The following information is limited to Remote I/O network coaxial
cable installations that are in metal conduit inside of a building.
Guidelines for fiberĆoptic cable installation are provided in
Appendix K. For information regarding other types of installations,
contact Reliance Electric.
Refer to section 3.5.1 for Remote I/O module installation procedures.
Refer to section 3.5.2 for Shark Interface module installation
procedures. Refer to section 3.5.3 for Remote I/O Head installation
procedures. Refer to section 3.5.4 for Remote Drive Interface Head
installation procedures.
DANGER
ONLY QUALIFIED ELECTRICAL PERSONNEL FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THIS EQUIPMENT AND THE HAZARDS
INVOLVED SHOULD INSTALL, ADJUST, OPERATE, OR SERVICE THIS
EQUIPMENT. READ AND UNDERSTAND THIS MANUAL AND OTHER
APPLICABLE MANUALS IN THEIR ENTIRETY BEFORE PROCEEDING. FAILURE
TO OBSERVE THIS PRECAUTION COULD RESULT IN SEVERE BODILY INJURY
OR LOSS OF LIFE.
DANGER
THE USER IS RESPONSIBLE FOR CONFORMING WITH ALL APPLICABLE
LOCAL, NATIONAL, AND INTERNATIONAL CODES. WIRING PRACTICES,
GROUNDING, DISCONNECTS, AND OVERCURRENT PROTECTION ARE OF
PARTICULAR IMPORTANCE. FAILURE TO OBSERVE THIS PRECAUTION
COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
WARNING
INSERTING OR REMOVING A MODULE MAY RESULT IN UNEXPECTED MACHINE
MOTION. POWER TO THE MACHINE SHOULD BE TURNED OFF BEFORE
INSERTING OR REMOVING A MODULE FROM THE NETWORK. FAILURE TO
OBSERVE THESE PRECAUTIONS COULD RESULT IN BODILY INJURY.
WARNING
THE USER MUST PROVIDE AN EXTERNAL, HARDWIRED EMERGENCY STOP
CIRCUIT OUTSIDE OF THE CONTROLLER CIRCUITRY. THIS CIRCUIT MUST
DISABLE THE SYSTEM IN CASE OF IMPROPER OPERATION. UNCONTROLLED
MACHINE OPERATION MAY RESULT IF THIS PROCEDURE IS NOT FOLLOWED.
FAILURE TO OBSERVE THIS PRECAUTION COULD RESULT IN BODILY INJURY.