Rockwell Automation 57C329 Remote I/O Communications, AutoMax - Manual (Page 40)

3Ć14
3.4.5 Constructing Long Cable Segments
To construct a cable segment longer than the standard maximum
cable spool length (over 1,000 feet for Belden 9259), use a BNC
jackĆtoĆjack inĆline splicing adapter. Use the following procedure to
construct a long cable segment:
Step 1.
Terminate both ends of the cable segment.
Step 2. Splice both parts using the jackĆtoĆjack adapter. See figure
3.16. Ensure the splicing connection can be accessed
easily.
ADAPTER
CONNECTOR
MATED
CABLE
ASSEMBLY
COMPLETED
INSTALLATION
BOOT
CONNECTOR
Figure 3.16 Ć Cable Splicing
Step 3. Isolate the splicing connection with an insulating jacket, a
boot, heat shrink tubing, or electrical sealant tape as
shown in figure 3.16.
Step 4. Document this connection on the cable system layout.