Rockwell Automation DeviceNet Media Design Installation Guide - Manual (Page 24)

Publication DNET-UM072C-EN-P - July 2004
1-14 Get Started
• open-style terminating resistors. 121 Ω , 1%, 1/4W or larger resistors
connecting the white and blue conductors in micro- or mini-style attach
to:
– open-style T-Port taps
– trunk lines using terminator blocks
• KwikLink flat cable terminating resistors
The 121 Ω resistor is contained in the snap-on interface module:
• sealed terminator with an Insulation Displacement Connector (IDC)
base (NEMA 6P, 13; IP67) catalog number 1485A-T1E4
• unsealed terminator with IDC base (no gaskets) (NEMA 1; IP60)
catalog number 1485A-T1H4
Network end caps are included with each KwikLink terminator; see page 3-14
for complete installation instructions.
Wire
Color Wire
Identity Usage
Round Usage
Flat
white CAN_H signal signal
blue CAN_L signal signal
bare drain shield n/a
black V- power power
red V+ power power
Blue
Red Black
White
Shield or Bare
121
Ω
41827
Catalog number 1485A-C2
end cap
terminating resistor with end cap
30490-M 30479-M