Rockwell Automation DeviceNet Media Design Installation Guide - Manual (Page 35)

Publication DNET-UM072C-EN-P - July 2004
Get Started 1-25
Spacing of DeviceNet cable from ac conductors, as specified in
publication 1770-4.1.
Both the programmable controller and DeviceNet scanner module
are in run mode.
IMPORTANT
* Devices default to node 63. Leave node 63 open to avoid
duplicate node addresses when adding devices. Change the
default node address after installation.
IMPORTANT
If your DeviceNet system does not run properly, see the
scanner module’s display and network and status LEDs for
help in troubleshooting.