Rockwell Automation LDC Iron Core Linear Servo Motors - Manual (Page 25)

Rockwell Automation Publication LDC-UM001B-EN-P - March 2011 25
Install the LDC-Series Linear Motor Chapter 3
3. Verify the dimension of the opening for the magnet track, coil, and cooling
plate if used.
4. Remove all burrs and clean the motor coil mounting surface.
5. Position the carriage toward the end of travel where you want the cable to
exit.
6. Install the motor under the carriage, using M5 x 0.8 bolts that extend
through the slide by at least 12 mm (0.5 in.), but no more then
20 mm (0.7 in.).
7. Tighten the screws but do not torque.