Mount a single coil with a single magnet track, Tighten screws but do not torque them, Slide the carriage assembly onto the bearing pucks – Rockwell Automation LDC Iron Core Linear Servo Motors User Manual
Page 29
Advertising
Rockwell Automation Publication LDC-UM001B-EN-P - March 2011
29
Install the LDC-Series Linear Motor Chapter 3
Mount a Single Coil with a Single Magnet Track
Follow these steps to install a single coil with single magnet track.
1.
Install the magnet track by using M5 x 0.8 x 16 mm SHCS.
2.
Remove any burrs and clean the motor-coil mounting surface.
3.
Install the motor coil under the carriage, by using M5 x 0.8 screws that
extend through the carriage by at least 12 mm (0.5 in.), but no more than
20 mm (0.7 in.).
4.
Tighten screws but do not torque them.
5.
Slide the carriage assembly onto the bearing pucks.
Advertising