Rockwell Automation FANM FanMaster Energy Saving Package - Manual (Page 37)

Allen-Bradley® FanMaster™ Energy Saving Package Installation Manual - Publication FANM-IN001B-EN-P – December, 2009 PN-65329
Chapter
3
FanMaster Configuration and Start Up
This chapter contains the steps necessary to configure and start up
FanMaster. Typical values are provided as defaults where applicable. The
default values may not be valid for your installation and, if left unchanged,
may affect the calculated energy savings results. Verify all values in
Table
3.A on page 3-2 prior to completing the configuration procedures.
Using the PanelView C600
HMI Terminal The PanelView C600 HMI terminal is a touch sensitive operator interface
that is used to monitor and program the controller in the FanMaster via a
pre-programmed HMI application. You can navigate the screens and edit
values by touching a location on the display. For a description of each
FanMaster screen, refer to
Appendix C - FanMaster Screens and Field
Descriptions .
For NEMA/UL Type 4 enclosures, loosen the two screws on the PanelView
terminal cover in order to lift the cover and access the PanelView HMI
terminal.
Important: Analog touch screens are intended for single presses at a time.
If the touch screen is pressed in two locations at the same time,
the presses are averaged as a single press in-between the two
locations.
PanelView C600
Touch
Display