Rockwell Automation GV3000 AC Pwr Module Ver. 5.0 Hardware Ref, Installation, and Troubleshooting - Manual (Page 15)

1Ć1
1.0 BECOMING FAMILIAR WITH THE MANUAL
This chapter provides help in finding information in the manual and describes the intended audience.
Also included are references to other related publications and instructions on receiving assistance
from Reliance Electric.
1.1 Finding Information
This instruction manual describes the GV3000 drive's Power Module and regulator hardware. It does
not cover the GV3000 software. For additional software information, refer to the GV3000 AĆC General
Purpose (V/Hz) and Vector Duty Drive Software StartĆUp and Reference Manual (D2Ć3339).
As an aid in finding information in this manual, each chapter is briefly described below:
D Chapter 1
Ć Becoming Familiar with the Manual
Provides information on how the manual is organized and where to find additional
information.
D Chapter 2 Ć About the Drive
Identifies drive components and shows their locations.
D Chapter 3 Ć Planning Before Installing
Presents information that must be considered when planning a drive installation.
D Chapter 4 Ć Mounting the Drive, Grounding, and Finding Wire Routing Locations
Describes how to mount the drive and properly ground it.
D Chapter 5 Ć Installing Input Power Wiring
Describes incoming AĆC and DĆC line components and how to properly connect
them.
D Chapter 6 Ć Installing AĆC Output Power Wiring
Describes output AĆC line components and how to properly connect them to the
motor.
D Chapter 7 Ć Wiring the Regulator Board Terminal Strip
Provides information on the I/O wiring that connects to the terminal strip on the
Regulator board.
D Chapter 8 Ć Completing the Installation
Provides instructions on how to perform a final check of the installation before
power is applied.
D Chapter 9 Ć Troubleshooting the Drive
Describes the equipment that is needed to troubleshoot the drive and how to
measure DĆC bus voltage. Replacement part lists are also provided.
D Appendix A Ć Technical Specifications
Lists drive specifications in table form.
D Appendix B Ć Drive Regulation Overview
Briefly describes volts/hertz and vector regulation.
D Appendix C Ć Compliance with EN 60204Ć1: 1992
Lists the sections of standard EN 60204Ć1: 1992 that the GV3000 drive complies
with.