Rockwell Automation GV3000 AC Pwr Module Ver. 5.0 Hardware Ref, Installation, and Troubleshooting User Manual
Page 71
7Ć15
Table 7.1 Ć Wiring Signal and Control I/O to the Terminal Strip (Continued)
БББББ
Б
БББ
Б
БББББ
Terminal
Number
ББББББББББ
Б
ББББББББ
Б
ББББББББББ
Description
БББББББББББББББББББ
Б
БББББББББББББББББ
Б
БББББББББББББББББББ
Parameters/Wiring Connections
ББББББББББББББББББББББББББББББББ
ББББББББББББББББББББББББББББББББ
Wiring the Output Status Relays
28
29
30
31
NormallyĆClosed Contact
(Form B)
NormallyĆClosed Contact
Common (Form B)
NormallyĆOpen Contact
(Form A)
NormallyĆOpen Contact
Common (Form A)
Both Form A and Form B contacts are rated for
250 VAC/30 VDC at 5 amps resistive or 2 amps inductive
load.
The following parameter must be set:
P.013: Output Relay Configuration
Note that depending on the setting of parameter P.013, the
relay coil will energize (the normallyĆopen contact will close
and the normallyĆclosed contact will open). Refer to the
GV3000 Programming instruction manual (D2Ć3339) for
more information.