Rockwell Automation GV3000 AC Pwr Module Ver. 5.0 Hardware Ref, Installation, and Troubleshooting - Manual (Page 92)

AĆ2
Table A.3 Ć Terminal Strip Input Specifications
Signal Type Terminal(s) Specification
Speed Reference Input 12Ć15 10 V (@ 50K ohm input
impedance or 20 mA)
Digital Inputs (1 Ć 8) 16 +24 VDĆC Isolated Supply
17 Remote/Local (Default)
18 Ramp1/Ramp2 (Default)
19 Forward/Reverse (Default)
20 Function Loss
21 Run/Jog
22 Reset
23 Stop
24 Start
Table A.4 Ć Terminal Strip Output Specifications
Signal Type Terminal(s) Specification
Analog Output 10 Ć11
scaled signal
0Ć10 VDĆC or 4Ć20 mA
Snubber Resistor 26 Ć 27 Used with Snubber Resistor
Braking Kits Ć Refer to Instruction
Manual D2Ć3179.
Table A.5 Ć RSĆ232 Specifications
Signal Type Terminal(s) Specification
RS 232 Communications 1 XMIT
2 RECV
3 COMMON
Table A.6 Ć Speed Feedback Device Specifications (Vector Regulation Only)
Specification Rating
Motor Poles 2, 4, 6, or 8 poles
Overcurrent IET 200% load (based on drive nameplate rating)
Overload Current Rating 150% for 1 minute (based on drive nameplate rating)
Speed Control Range 1:600 with 1024 PPR
Speed Control Response 15 Hz (typical)
Speed Feedback 15 V differential quadrature, pulse tachometer
incremental (512 PPR, 1024 PPR, 2048 PPR,
4096 PPR)
Service Factor 1.0