Rockwell Automation GV3000 AC Pwr Module Ver. 5.0 Hardware Ref, Installation, and Troubleshooting User Manual
Page 70
7Ć14
Table 7.1 Ć Wiring Signal and Control I/O to the Terminal Strip (Continued)
БББББ
Б
БББ
Б
БББББ
Terminal
Number
ББББББББББ
Б
ББББББББ
Б
ББББББББББ
Description
ББББББББББББББББББ
Б
БББББББББББББББББ
ББББББББББББББББББ
Parameters/Wiring Connections
БББББББББББББББББББББББББББББББ
БББББББББББББББББББББББББББББББ
Wiring the Reset Input
22
Digital Input 3
(Reset)
The following parameter must be set:
P.000: Control Source
Terminal 22 On = Reset
БББББББББББББББББББББББББББББББ
БББББББББББББББББББББББББББББББ
Wiring the Stop/Start Inputs
23
24
Digital Input 2
(Stop)
Digital Input 1
(Start)
The following parameter must be set:
P.000: Control Source
P.025: Stop Type
Terminal 23 Off = Stop
Terminal 24 On Transition = Start
БББББ
БББББ
25
ББББББББББ
ББББББББББ
24 VDC Isolated Common
ББББББББББББББББББ
ББББББББББББББББББ
БББББББББББББББББББББББББББББББ
БББББББББББББББББББББББББББББББ
Wiring the Snubber Resistor
БББББ
Б
БББ
Б
Б
БББ
Б
Б
БББ
Б
БББББ
26
27
ББББББББББ
Б
ББББББББ
Б
Б
ББББББББ
Б
Б
ББББББББ
Б
ББББББББББ
Snubber Resistor Braking
Control Signal
+24 VDC Isolated Common
ББББББББББББББББББ
Б
БББББББББББББББББ
Б
БББББББББББББББББ
Б
БББББББББББББББББ
ББББББББББББББББББ
Used with Snubber Resistor Braking Kit M/N 2DB4010.
Refer to the kit's instruction manual for installation
instructions.