Rockwell Automation GV3000 AC Pwr Module Ver. 5.0 Hardware Ref, Installation, and Troubleshooting User Manual

Page 66

Advertising

7Ć10

Table 7.1 Ć Wiring Signal and Control I/O to the Terminal Strip (Continued)

БББББ

БББ

БББББ

Terminal

Number

ББББББББББ

ББББББББ

ББББББББББ

Description

ББББББББББББББББББ

БББББББББББББББББ

ББББББББББББББББББ

Parameters/Wiring Connections

БББББББББББББББББББББББББББББББ

Wiring a Remote/Local Input

+24 VDC Power Supply

Current limited for remote input logic use only.

БББББ

ББББББББББ

Digital Input 8

(Default Ć Remote/Local)

ББББББББББББББББББ

Digital input 8 is control function programmable through

parameter P.007.

БББББББББББББББББББББББББББББББ

ББББББББББББББББББББББББББББББ

ББББББББББББББББББББББББББББББББ

WARNING

IF A MAINTAINED START CONTACT IS USED WHEN THE CONTROL SOURCE = rE,

SWITCHING FROM LOCAL TO REMOTE FROM THE TERMINAL STRIP WILL CAUSE POWER

TO BE APPLIED TO THE MOTOR IF THE REMOTE START CONTACT IS CLOSED. STAY CLEAR

OF ROTATING MACHINERY IN THIS CASE. FAILURE TO OBSERVE THIS PRECAUTION COULD

RESULT IN BODILY INJURY.

The following parameters must be set:

P.000: Control Source

(Only active when P.000 = rE)

P.006: Second Menu Password
P.007: Terminal Strip Digital Inputs Configure (Selects

and assigns a control function to digital inputs

6 to 8).

P.008: Terminal Strip Speed Reference Source

(Analog, Motor Operated Potentiometer (MOP), or

Preset Speeds)

Note that based on the settings of parameters P.000, P.007,

P.008, and r.030 if an RMI board is used, the following

parameters can affect digital input 8.

P.023: MOP Accel/Decel Time
P.024: MOP Reset Configuration
P.031 to P.038: Preset Speeds 1Ć8

Refer to the GV3000 Programming instruction manual

(D2Ć3339) for additional information.

Terminal 17 On = Local Control

Diagram shows factory setting.

Advertising

Popular Brands

Popular manuals