Rockwell Automation GV3000 AC Pwr Module Ver. 5.0 Hardware Ref, Installation, and Troubleshooting - Manual (Page 63)

7Ć7
7.3 Wiring the Signal and Control I/O
Wire the drive's signal and control I/O to the terminal strip as shown in table 7.1.
Table 7.1 Ć Wiring Signal and Control I/O to the Terminal Strip
БББББ
Б БББ Б
БББББ
Terminal
Number
ББББББББББ
Б ББББББББ Б
ББББББББББ
Description
БББББББББББББББББББ
Б БББББББББББББББББ Б
БББББББББББББББББББ
Parameters/Wiring Connections
ББББББББББББББББББББББББББББББББ
ББББББББББББББББББББББББББББББББ
Wiring RSĆ232 Signals
1
2
3 RSĆ232 Transmit
RSĆ232 Receive
RSĆ232 Signal/Regulator
Common
Note that RSĆ232 communication between the GV3000
drive and a personal computer requires the use of the
Control and Configuration software. Refer to instruction
manual D2Ć3348 for more information.
These terminals should only be used when the RSĆ232 port
(J8) or an Operator Interface module (OIM) are not being
used, as all three devices use the same transmit/receive
lines.
ББББББББББББББББББББББББББББББББ
ББББББББББББББББББББББББББББББББ
Wiring Pulse Tachometer Inputs
4Ć9 Pulse Tachometer Wiring See section 7.2.