Rockwell Automation 1794-Lxxxx PhaseManager - Manual (Page 106)

104 Publication LOGIX-UM001B-EN-P - April 2010
Appendix B PHASE Data Type
PHASE Data Type
NewInputParameters To clear the NewInputParameters bit, use an Equipment Phase New Parameters (PRNP)
instruction.
Producing Use bit-level instructions or an assignment to set or clear this bit (for example, OTE, :=).
Standby Use bit-level instructions or an assignment to set or clear this bit (for example, OTE, :=).
Member Control Method
If you want to Then check this
member Data type Notes
use one member to monitor the state of an
equipment phase State DINT Read–only
For this state: Use this bit:
Running 0
Holding 1
Restarting 2
Stopping 3
Aborting 4
Resetting 5
Idle 6
Held 7
Complete 8
Stopped 9
Aborted 10
see if the equipment phase is in the running
state Running BOOL Read–only
see if the equipment phase is in the holding
state Holding BOOL Read–only
see if the equipment phase is in the restarting
state Restarting BOOL Read–only
see if the equipment phase is in the stopping
state Stopping BOOL Read–only
see if the equipment phase is in the aborting
state Aborting BOOL Read–only
see if the equipment phase is in the resetting
state Resetting BOOL Read–only
see if the equipment phase is in the idle state Idle BOOL Read–only
see if the equipment phase is in the held state Held BOOL Read–only
see if the equipment phase is in the complete
state Complete BOOL Read–only