Rockwell Automation Logix5000 Control Systems: Connect PanelView Plus Terminals over EtherNet/IP Quick Start - Manual (Page 22)

22 Rockwell Automation Publication IASIMP-QS033A-EN-P - March 2012
Chapter 2 Create a PanelView Plus Application
• Install an I/O module with the following conditions:
– Accessible to the PanelView Plus terminal over the EtherNet/IP network
– Included in the RSLogix 5000 project used with this quick start.
This publication uses a 1769-OB16 digital output module.
• Prepare the PanelView Plus terminal as described in Chapter 1, Prepare the PanelView Plus
Terminal Hardware on page 13 , including:
– Mount the PanelView Plus Terminal
– Connect the Power Supply
– Connect the PanelView Plus Terminal to the EtherNet/IP Network
– Assign an IP Address to the PanelView Plus Terminal
What You Need
You need the following software to complete the tasks described in this chapter:
• FactoryTalk View Studio software
• RSLinx Enterprise software
• RSLogix 5000 software
IMPORTANT This section describes how to install FactoryTalk View Studio software and RSLinx
Enterprise software.