Rockwell Automation Logix5000 Control Systems: Connect PanelView Plus Terminals over EtherNet/IP Quick Start - Manual (Page 5)

Rockwell Automation Publication IASIMP-QS033A-EN-P - March 2012 5
Preface
This quick start provides examples and procedures for including a PanelView

Plus terminal in a
Logix5000

control system over an EtherNet/IP network. The programming examples are not
complex, and offer easy solutions to verify that devices are functioning and communicating
properly.
Before Using This Publication
You can only use the tasks described in this publication after first completing some prerequisite
tasks with a Logix5000 controller. For example, before you can add a PanelView Plus terminal to
an RSLogix

5000 project, as described on page 21 , you must first create the project in a
Logix5000 controller.
Table 1 describes the tasks you must complete before using this publication.
For more information on how to complete these tasks with specific Logix5000 controllers, see
the Integrated Architecture

: Logix5000 Control Systems Quick Starts Quick Reference,
publication IASIMP-QR024 .
IMPORTANT This publication describes basic example tasks you can complete when using a PanelView Plus terminal on an
EtherNet/IP network. The tasks described are not the only tasks you can complete with the terminal on an EtherNet/IP
network.
IMPORTANT The example graphics shown in Table 1 - Required Tasks To Complete Before Using This Quick Start on page 6 are for
CompactLogix 5370 L3 controllers. Depending on the Logix5000 controller you are using, the specific steps to complete
the tasks described in the table might vary.