Table 1, Desc – Rockwell Automation Logix5000 Control Systems: Connect PanelView Plus Terminals over EtherNet/IP Quick Start User Manual
Page 6
6
Rockwell Automation Publication IASIMP-QS033A-EN-P - March 2012
Preface
Table 1 - Required Tasks To Complete Before Using This Quick Start
Task
Description
Prepare the Logix5000
control system
hardware
Assemble the control system and connect to necessary communication networks. Some components, for
example, the desired Logix5000 controller and system power supply, are required. Other components, for
example, a network communication module, are optional.
These graphics show the assembly of an example Logix5000 controller.
IMPORTANT: This task does not include installation of specific hardware components, for example, PanelView
Plus terminals, used over the networks included in your application.
Prepare the computer Install necessary software, such as RSLogix 5000 software, on your computer.
2 (Rear)
1 (Front)