Metrohm tiamo 1.3 Manual - Manual (Page 152)

126 Workplace
6 - Main run
When processing the loaded method the following actions can be carried out:
• Process series start track
At the start of the first determination in a series the Series start track is
started. If during the run of this track
[Stop] is pressed then the Exit track
will start; if an error occurs the Error track starts.
• Process main track
After the start of the Main track the status changes to
BUSY . The commands
of the main track and the other tracks that it calls up are processed in se-
quence. If the main track calls up tracks that are not free then a pause will
be made until these tracks can be started.
• Interrupt and continue run
A running determination can be interrupted at any time with
[Hold] and then
continued with [Cont] . All the active tracks will be stopped and continued
together.
• Interrupt and continue series
A running series can be interrupted at any time with
[Pause] . The determina-
tion that is running in the series will be completed, but no new determina-
tion will be started. With [Cont] the next determination in the interrupted
sample series will be started.
• Cancel sequence
A running determination can be canceled at any time with
[Stop] . An Exit
track may be carried out; the determination will be terminated.
• Cancel by error
If when a determination is being carried out an error occurs that causes the
cancellation of the determination then an Error track may be carried out; the
determination will be terminated.
• Process exit track
When the main track and all the other tracks that is has called up have
been completed then an Exit track may be carried out; the determination
will be terminated.
• Process series end track
At the end of the last determination in a series the Series end track will start.
If when this track is being processed
[Stop] is pressed then the determina-
tion will be terminated, if an error occurs then the Error track starts.
7 - Post-conditioning (only for methods with conditioning)
In methods that contain commands with switched-on conditioning and in which
the option
Automatic conditioning is switched on in the START command then for all
these commands post-conditioning will be started automatically with the loaded
method immediately after the end of the track that contains the conditioning
command. After the start of post-conditioning the status changes to
COND BUSY .
In this status the conditioning can be stopped with [Stop] or interrupted with [Hold]
and continued with [Cont] . If an error occurs during conditioning then neither the
Error track nor the Exit track will be carried out.
• Conditioning between two determinations
Conditioning will continue to run until the new method is loaded for the next
determination.
• Conditioning at the end of the last determination
After the Series end track has been carried out conditioning will continue to
take place until it is terminated with
[Stop] .