Metrohm tiamo 1.3 Manual - Manual (Page 168)

142 Workplace
3.7 Subwindow Live display
3.7.1 General
Subwindow Live display
In the two subwindows Live display 1 and Live display 2 the live curves, measured
values and messages about the method started on the tab Single determination or
Determination series are shown. The subwindows can be switched on in the pro-
gram part Workplace in the definition of the Layout and become visible. They can
be enlarged and diminished as required; they can also be maximized.
The display of curves and measured values in the live window can be defined per
window and per command type under Properties.
Tabs
The subwindows Live display 1 and Live display 2 consist of the following tabs:
• Track
A tab marked with the name of the track is shown for each track.
• Application note
Shows the application note defined in the START command.
3.7.2 Tracks
For each track of the loaded method a tab will be shown in the subwindow Live
display that is labeled with the name of the track. On these tabs the live display
components defined under Properties (curve, measured value, message) will be
shown for the currently active command. The tabs must be changed manually, i.e.
no automatic switch is made if a different track is called up. This means that it is
possible to show two active tracks simultaneously in two live windows located
side by side.
At the start of the determination the contents of the track tabs are deleted. Then
the messages, curves and measured value displays generated by the active
command appear on the tabs. The title of the tab is shown in red for the active
track. In addition the command type and command name of the active command
are shown in the window title of the subwindow Live display .
If all tracks are halted with [HOLD] or if individual tracks are halted with a SEND
command then Track halted... will appear in these tracks.
When the track has finished then Track finished will appear in all tracks with the ex-
ception of the main track. Depending on the sequence the following will be shown
in the main track when the determination has been completed:
Run: Regular without remarks
The determination has been terminated automatically after it has pro-
ceeded regularly and without comments.
Run: Regular with remarks
The determination has been terminated automatically after it has pro-
ceeded regularly, but with comments (see Information window in Data-
base).
Run: Abort
The determination or the conditioning was stopped manually with [Stop] , by
stop criteria or by a SEND command.