Metrohm tiamo 1.3 Manual - Manual (Page 814)

788 Configuration
Column display
With Edit, Column display... the dialog window Column display opens. Here you can
define the columns to be shown in the Sensor table.
Columns available
Shows all the fields that can be shown as columns in the Sensor table.
Columns displayed
Shows all the fields that will be shown as columns in the Sensor table. The
default situation is that the columns
Sensor name, Sensor type, Measuring in-
put, Start up, Expiry date, Slope, pH(0)/E(0) and Next calibration will be
shown. The two columns Sensor name and Sensor type are always present
and cannot be removed.
Adds the selected column to the table.
Removes the selected column from the table.
Alters the sequence of shown columns by moving the selected column up-
ward or downward.
Add new sensor
In order to add a new non-intelligent sensor to the Sensor table the menu item
Edit, New must be pressed and then one of the following possible sensor types
must be selected: