Metrohm tiamo 1.3 Manual - Manual (Page 466)

440 Method
Commands
Depending on the measured value one of the following two STAT commands can
be chosen:
• STAT pH
STAT Titration with pH electrodes (measuring quantity pH).
• STAT U
STAT Titration with metal electrodes (measuring quantity U).
Control range
Set a large control range for steep curves and a small control range for flat ones.
A good approximation for the start of the control range is given by the point where
the tangents intersect.
STAT pH
Command for STAT titrations with measured value pH.
Devices
This command can be executed with the following devices which have the STAT
pH mode:
Titrino: 718, 736, 751, 799
Titrando: 835, 836, 842, 855, 857
Appearance
The command has the following appearance:
Parameters
The parameters for the command STAT pH are configured in the following 8 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.