Metrohm tiamo 1.3 Manual - Manual (Page 467)

Commands 441
• Start conditions
Parameters for the measurement of the initial measured value and for defin-
ing the conditions which have to be met at the start of the titration.
• Control parameters
Parameters for the control point.
• Titration parameters
Parameters for the run of the titration.
•
Stop conditions
Definitions of conditions which cause the stop of the titration.
•
Monitoring
Definition of measured value, dosing rate, and temperature monitoring.
• Evaluations
Definition of methods for evaluation of the titrations curves.
• Additional measured values
Definition of additional measured values of other measuring commands
which are saved as additional column in the list of measuring points.
General/Hardware
The general parameters for the control device, the dosing device, sensor and the
stirrer are defined on this tab.