Metrohm tiamo 1.3 Manual - Manual (Page 612)

586 Method
on, [ off ]
Switch off the stirrer.
Duration
on, [ off ]; 0 ... [ 10.0 ] ... 9'999.9; s, [ min ]
Switch on the stirrer for a particular period.
RACK
Command for Initialization of the attached sample rack. The rack, lift and ro-
botic arm (if existing) are reset, the rack code is read off and the corresponding
rack data are transferred to the Sample Processor.
Devices
This command can be executed with the following devices:
Sample Processor: 730, 774, 778, 789, 814, 815, 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command RACK are configured in the following dialog win-
dow:
•
RACK
RACK - properties
Command name
25 characters, [ Initialize rack # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ 814 USB Sample Processor ]