Ultra-cut 100 xt – Tweco 100 Ultra-Cut Plasma Cutting System with Automated Gas Control User Manual
Page 59
Advertising
ULTRA-CUT 100 XT
Manual 0-5303
INSTALLATION
3-35
2. Refer to illustration. Connect the Pilot wire and Negative cables using a star washer on each.
NOTE
* Slave and Master refer to only those set ups using two power supplies in parrallel. Slave is not used
in single system operations.
*Negative (Master)
Torch Lead
Pilot
Art # A-12063_AB
*Negative (Slave)
Negative Master, Negative Slave and Pilot Cables (from Power Supply )
Art # A-12064
Control Cable from Power Supply rear panel
Advertising