Tweco 100 Ultra-Cut Plasma Cutting System with Automated Gas Control - Manual (Page 75)

ULTRA-CUT 100 XT
Manual 0-5303 OPERATION �-5
4.05 TSC-3000 Selecting New Process
Art # A -09160
Select process by # (2) or by
name (3).
If by name, first select
process type; best cut,
fastest, MAX Pierce, etc.
Then press
To accept &
advance to Torch
Consumables. (4
).
4
3
Material –
Scroll to select,
Thickness –
Scroll to select,
Accept & advance (1).
SELECT PROCESS
1
2
HOME
SELECT MATERIAL, THICKNESS
SELECT PROCESS NUMBER
6
Confirm the listed torch
consumables are installed in
the torch.
Go to THC / CNC settings for
cutting (5).
Select new standard process by material; thickness; amperage (1)
or enter process # using pop-up number pad (2).
5
PROCESS MONITOR
Now you are ready to start cutting. Displayed Amps Demand is the output current
setting, not the actual current.
As soon as Start is applied Process Monitor shows output voltage, gas pressures,
status of Start, OK to Move and Gas On signals. Here you can toggle between Plasma
Marking with the selected consumables and cutting.
Toggle between Cut &
Marking settings (6).
Proceed to Process Monitor
(7).
7
TORCH CONSUMABLES THC / CNC Settings (Cutting)
THC / CNC Settings (Marking)