Tweco 100 Ultra-Cut Plasma Cutting System with Automated Gas Control - Manual (Page 61)

ULTRA-CUT 100 XT
Manual 0-5303 INSTALLATION 3-37
3. The Arc Starter must be grounded; the grounding terminal is marked . Refer to the previous section for
grounding details.
Ground Cable
Art # A-04758
1 Nut and 1 Washer
Remain in Place
Torch Leads
4. Use a clamp to secure the Torch Lead Shield braid brass ring to the port on the Remote Arc Starter as shown.
Art # A-04759
Coolant and Pilot Leads
to Torch Valve Assembly
Torch Leads Shield
Shield Clamp