Replace left end plates, Install new top seal, Replace left end plates install new top seal – Great Plains 2007HD Update Installation User Manual
Page 23: W seal at step 104
Great Plains Manufacturing, Inc.
Update Meters
19
05/25/2011
166-370M
Replace Left End Plates
Refer to Figure 31
97. For each meter, select one new:
168-472D METER SHAFT MOUNT PLATE
one saved:
890-466C HSG RIBB FLG 6BOLT PLT
and six sets new:
802-001C HHCS 1/4-20X3/4 SS
804-033C WASHER LOCK 1/4 SS
98. Apply silicone sealant to the outer rim of the
flange
, under bolt heads and under washer
faces. Secure the flange
to the plate
.
Smooth excess sealant to fillet shape.
99. Select one each saved:
166-308/20/21S 4-OUTLET STAR SHAFT ASY
266-187D METER SENSOR MOUNT
and one new:
816-693C AIR DRILL METER SHAFT GASKET
and six sets new:
802-001C HHCS 1/4-20X3/4 SS
804-033C WASHER LOCK 1/4 SS
100. Insert the shaft
through the gasket
, left wall
of meter, and bearing at right wall of meter.
101. Place lock washers
on all bolts
. Insert two
of the bolts through the sensor mount
. The
sensor mount uses the top
and top-front
bolt
holes at the left meter wall.
102. Secure the plate
to the left end of the meter with
bolts
and lock washers
.
Install New Top Seal
Refer to Figure 32
103. At each meter, clean and de-grease the top panel
in the area between the outer flange and the new
inner flange.
104. Select one new:
816-662C METER TOP SEAL
Before removing the release paper backing, make a
trial fit of the seal on the top panel.
105. Remove the backing paper. Bond the seal
to
the top panel.
Figure 31
Left Shaft Mount Plate
Q0103
918
942
231
959
125
977
139
U
D
F
B
L
R
4
5
918
231
942
959
231
231
918
125
139
977
942
959
125
977
959
942
139
4
5
Figure 32
Install Top Seal
Q0103
976
6
918
942
959
6
976
976