Connect wsmb #3 – Great Plains 2007HD Update Installation User Manual
Page 54
50
NTA607HD or NTA2007HD
Great Plains Manufacturing, Inc.
166-370M
05/25/2011
Refer to Figure 77 (on page 45) and Figure 78 (which is part
of the full harness diagram found on page 88 and 89)
296. If WSMB
(on Tower D) does not have a WSMB
harness connected, select one saved:
467981201A INT AG HARNESS, WSMB MODULE
Connect the 12-pin receptacle leads
WSMB
.
297. Connect the 4/6-pin CANbus plug leads
4/6-pin CANbus receptacle leads
extension harness
298. Select a saved:
299. Connect the WSMB’s 12-pin plug leads
12-pin receptacle leads of the row harness
300. Use cable ties to secure the row harness core to
Tower D.
301. Select two saved 4.6 m (15ft) extensions:
459680922 EXT. HARNESS 15’ FAN RPM
Connect these to harness sensor leads 1 and 2.
302. Connect the 3-pin sensor leads
or extensions to
their respective seed row blockage sensors, per the
chart on page 86 and the diagram on page 89. The
rows requiring extensions are off the illustration at
right - see page 89.
303. Select four new (not shown):
464211090 DUST PLUG
Cap the ends of the four unused harness leads
(leads 13 to 16, also not shown).
Figure 82: Tower D
Q0118
WSMB
5
WSMB
3
467751330S1
4 Leads
Un
used
D
c
b
d
932