Enumerate wsmbs – Great Plains 2007HD Update Installation User Manual
Page 46
42
NTA607HD or NTA2007HD
Great Plains Manufacturing, Inc.
166-370M
05/25/2011
252. Working from right to left along the implement, dis-
connect, dismount and save all WSMBs
, row
harnesses
, and sensor lead extensions (
,
).
Refer to Figure 71
At Towers B-G, also remove and save any CANbus
extensions
. At Tower A, do not remove the
CANbus extension
Output Module).
253. Sort the removed harness components into groups
by part number.
Enumerate WSMBs
To ease configuration and operation of the
DICKEY-john
®
IntelliAg
®
console, install the WSMBs in
serial number order. This causes the initial automatic
sensor-to-row assignments to be correct by default.
Refer to Figure 72
254. Select one new:
467981100S1 INTAG WSMB MODULE 18R
Apply some tape, and label this WSMB “6”. As a
new module, it should have a serial number higher
than any installed modules. (If any WSMBs on this
air drill have ever been replaced, check that the new
WSMB
is indeed the highest number.)
255. Select all of the saved:
467981100S1 INTAG WSMB MODULE 18R
Sort them in order of serial number
. Label them,
in ascending serial number order as “1” through “5”.
Separately record the serial numbers and applied
ID numbers (for use at step 392 on page 67).
Figure 71
POM at Implement Center
32147
Figure 72
,
WSMB-18R
31434
934
7
6
934
934
7