Update implement hydraulics, Extend valve hoses, Relocate valve group – Great Plains 2007HD Update Installation User Manual
Page 58
166-370M
05/25/2011
54
NTA607HD or NTA2007HD
Great Plains Manufacturing, Inc.
Update Implement Hydraulics
Extend Valve Hoses
The weight transfer valve group is relocated to improve
visibility from the tractor cab. Extend hoses prior to valve
relocation. Extend hoses one at a time to eliminate the
need to mark hoses or trace routes. See “Hydraulic
Connectors and Torque” on page 70.
Refer to Figure 88
323. Select one set new:
811-430C AD 3/4MJIC 3/4MJIC
811-831C HH1/2R2 034 3/4FJIC
Open the
3
⁄
4
in connection at
. Insert the new
hose
and adaptor
.
324. Select four sets new:
811-315C AD 9/16MJIC
811-701C HH3/8R2 033 9/16FJIC
One at a time, open a
5
⁄
16
in connection at
a new hose
and adaptor
. Of the five new
hoses, three are clamped to the wing near the piv-
ots. Route these under any existing hoses (see
Figure 90 on page 55).
Relocate Valve Group
Refer to Figure 89
325. Remove and save two sets:
804-022C WASHER LOCK SPRING 5/8 PLT
and one:
806-105C U-BOLT 5/8-11 X 4 1/32 X 6
326. Relocate the valve group:
160-331S NTA607HD HYDRAULIC VALVE ASY
further outboard on the wing. The new U-bolt
center-line is approximately 3.8 cm (1.5 in) inboard
of the inside rear face of the wing gauge wheel
plate
. Secure valve group with saved U-bolt
,
lock washers
and nuts
327. Remove or obscure the existing operating decals:
848-504C DECAL WING DOWN PRESSURE PIC
848-505C DECAL FRAME BACK PRESSURE PIC
328. Clean and dry the top surface of the wing tool bar
on either side of the relocated valve group.
329. Select one each new:
848-504C DECAL WING DOWN PRESSURE PIC
848-505C DECAL FRAME BACK PRESSURE PIC
Apply
848-505C
to the left of the valve group. Apply
848-504C
to the right. Apply to the top or front of the
tool bar left of the group. Apply to the top or front of
the tool bar at right, or to the inside face of the
gauge wheel mount (clear of lock channel storage).
Figure 88
Existing Valve Group Hoses
Q0128
3
9
High Pressure Fluid Hazard:
Wear gloves and eye protection. Open (“crack”) hydraulic
connections slowly. Even with the systems set to Float prior to
unhitching, there may still be residual pressure in some lines. if
an injury occurs, seek immediate attention from a physician
familiar with this type of injury.
972
974
3
974
972
970
973
973
970
Figure 89
Weight Transfer Valves
Q0053
1
1
979
980