Close-out, Reconfigure monitor, Close-out reconfigure monitor – Great Plains 2007HD Update Installation User Manual
Page 71
05/25/2011
166-370M
Great Plains Manufacturing, Inc.
67
Close-Out
382. Remove all part number tags, grease-pencil and
paint-pencil part numbers.
383. If a suitable tractor and field are available, test all
hydraulic functions. Also perform some passes to
confirm coulter to row alignment.
Reconfigure Monitor
The DICKEY-john
®
IntelliAg
®
WSMT is still programmed
with the prior bus configuration of this air drill. When first
powered-up after the update, the monitor is likely to dis-
play an alarm when it discovers the new WSMB. Even
without an alarm, the sensor to row assignments are
incorrect.
These instructions presume that the monitor already has
Materials and Channels defined.
The steps below require a password to enter User
Level 2. Consult the IntelliAg
®
ACC manual (
384. Set the Master Switch off.
385. Power up the monitor (turn on tractor ignition).
386. If a configuration error is detected (virtually certain
on the first power-up), press the Alarm Cancel
(CANCEL) softkey.
387. Press NEXT PAGE softkey until the MODULE CFG
softkey appears.
388. Press the MODULE CFG softkey.
389. Press the AUTO CONFIG softkey.
390. Press the AUTO SORT softkey.
391. Move the WSMT-ACCGP to MODULE ADDR 1.
392. Press the ROW ASSIGN softkey. Verify that the row
assignments are as shown in the table at right. See
ACC manual for how to re-order assignments.
393. Press the CTRL SETUP softkey.
Note: Consult the factory on the next steps. A monitor
firmware update was pending when this manual
was initially released, and the exact softkey se-
quences were not yet documented.
This completes the update.
Figure 106
Monitor Console
25421
WSMB
ID
a
a. This is the hand-applied number from “Enumerate
MODULE
# OF
ROWS
ROW
#’s
ADDR.
Type
1
Note
b
b. These numbers are not shown, as they vary
depending on POM and the serial numbers of
WSMB modules not used for material rate sensing.
WSMB-18R
12
1-12
2
Note
WSMB-18R
16
13-28
3
Note
WSMB-18R
12
29-40
4
Note
WSMB-18R
12
41-52
5
Note
WSMB-18R
16
53-68
6
Note
WSMB-18R
12
69-80