Great Plains 2007HD Update Installation - Manual (Page 63)

Great Plains Manufacturing, Inc. Table of Contents Index Re-Hitch Implement 59
05/25/2011 Table of Contents Index 166-370M
Re-Install Link Lift Cylinders
Refer to Figure 95
343. Select two sets saved:
160-754D NTA607 PULL LINK CYLINDER LUG
805-187C PIN CLEVIS 1 X 2 1/4 GR5 PLT
805-104C PIN COTTER 3/16 X 1 1/2 PLT
Pin the narrow end of each lug in the rear
holes of the pull link lugs. Secure pin with
cotter
.
344. Select the saved lift cylinders:
810-170C CYL REP 3.5X10X1.25 ROD (TIE)
and four sets saved:
805-124C PIN CLEVIS 1 X 3 11/16 GR5 PLT
2A0132 MW PIN CLIP
Orient the cylinders with the hydraulic fittings facing
up. Connect the base ends to the upper holes of the
main frame plates. Connect the rod ends to the lugs
installed at step 343. Secure pins with clips.
Re-Install Weight Transfer Cylinders
Refer to Figure 96
345. Select the saved weight transfer cylinder
810-219C CYL 3.5X16X2 ROD (TIE ROD)
that has the transfer solenoid valve . This is the
right hand cylinder.
346. Orient the hydraulic fittings to center. Connect the
base end to the upper cart lug using the saved:
2A0206 MW PIN SHORT
2A0132 MW PIN CLIP
347. Connect the rod end to the back pressure flex
link using the saved:
2A0132 MW PIN CLIP
805-124C PIN CLEVIS 1 X 3 11/16 GR5 PLT
348. Select the other saved weight transfer cylinder:
810-219C CYL 3.5X16X2 ROD (TIE ROD)
and the saved pins and clips. Orient the hydraulic
fitting to center. Connect the base end of the cylin-
der to the upper cart lug. Connect the rod end to the
back pressure flex link
. Secure pins with clips.
Figure 95
Install Link Lift Cylinders
31238
205
115
199
195
141
197
205
115
199
195
199 115
195
205
197
141
Figure 96
Install Weight Transfer Cylinders
Q0047
2
140
141
140
206 109
206
2
140
141
109
141
197
206
109