Re-install arm, Re-attach spring, Re-install arm re-attach spring – Great Plains 2007HD Update Installation User Manual
Page 68
64
NTA607HD or NTA2007HD
Great Plains Manufacturing, Inc.
166-370M
05/25/2011
Re-Install Arm
Refer to Figure 103
360. Select the arm assembly. Arms are different for left
and right. Check the orientation of the disc guard.
Attach a hoist to the arm assembly
the new pivot frame (
or
). Guide the rod end
of the cylinder
onto the rear vertical pin of the
pivot frame.
361. At the rod end of the cylinder
, place the save:
and secure with saved cotter:
805-104C PIN COTTER 3/16 X 1 1/2 PLT
362. Select a saved:
SFM-8666 HAUKAAS SPRING HOLDER SFM
Place it on the forward vertical pin of the new pivot
frame (
or
), and secure with saved
802-130C HHCS 1/2-13X2 1/2 GR5
803-342C NUT HEX TOP LOCK 1/2-13 PLT
Re-Attach Spring
363. Attach the spring
to the spring holder
364. Tighten the lower jam nut
at the eyebolt
leave the top jam nut undisturbed.
365. Repeat step 351 through step 364 for the right side.
Figure 103
Re-Install Arm
Q0131
182
195
981
982
981
982
195
981
982
182