Great Plains 2007HD Update Installation - Manual (Page 51)

Great Plains Manufacturing, Inc. Table of Contents Index Update Harness 47
05/25/2011 Table of Contents Index 166-370M
Connect WSMB #4
Refer to Figure 79 (on page 45) and Figure 79 (which is part
of the full harness diagram found on page 88 and 89)
272. If WSMB
(on Tower A) does not have a WSMB
harness connected, select one saved:
467981201A INT AG HARNESS, WSMB MODULE
Connect the 12-pin receptacle leads into
WSMB .
273. Connect the 4/6-pin CANbus plug leads into the
4/6-pin CANbus receptacle leads of the
467981201A WSMB harness from WSMB .
274. Select a saved:
467751330S1 16 ROW HARNESS
275. Connect the WSMB’s 12-pin plug leads into the
12-pin receptacle leads of the row harness .
276. Use cable ties to secure the row harness core to
Tower E.
277. Select two saved 3m (10ft) extensions:
457901815 DJ HARNESS 10 FT EXT 3 PIN WP
Connect these to harness sensor leads 11 and 12.
278. Connect the 3-pin sensor leads or extensions to
their respective fertilizer row blockage sensors, per
the chart on page 87 and the diagram on page 88.
The rows requiring extensions are off the illustration
at right - see page 89.
279. Select four new (not shown):
464211090 DUST PLUG
Cap the ends of the four unused harness leads
(leads 13 to 16, also not shown).
280. Select one saved:
467980141 10’ EXT HARNESS
Connect the plug end of this harness to the
receptacle end of the WSMB harness .
Route the cable toward Tower B. Route the cable at
the left wing pivot so that it passes through pivot
centerline, and has just enough slack for wing fold-
ing.
Figure 79: Tower A/E
WSMB #4 Connections
Q0118
SMB
1
WSMB
4
467751330S1
4 Leads Un
used
E
c
b
b
d
a
150
148
142
e
e
153
152
153
a
A
#4
153
c
#4 152
a
b
153 #1
148
d
148
142
e
932
150
a
b #4 153