Install pull bar anchors, Install left anchor, Install right anchor – Great Plains 2007HD Update Installation User Manual
Page 29: Install left anchor install right anchor
Great Plains Manufacturing, Inc.
Update Cart
25
05/25/2011
166-370M
Install Pull Bar Anchors
Install Left Anchor
Refer to Figure 39 and Figure 40
132. Jack up the side of the cart sub-frame being worked
on. Dismount the wheel for access to the welding
site.
133. Select one new:
266-302D NTA2007 PULL BAR ANCHOR
134. Position the anchor
on the outside (wheel side)
of the subframe leg
, with the anchor’s larger hole
aligned with the existing hole
in the leg plate.
135. Mark the left at the edges of the anchor. Remove
the paint from the leg in this weld region.
136. Make sure the break in the small-hole end of the
anchor is pointing forward and toward cart center,
with the lower edge parallel to the cart frame. The
break should be pointing directly at a hole on the
new hitch pull bar plate.
137. Clamp the anchor in this position. Tack weld.
138. Finish weld all around with a 13 mm (
1
⁄
2
in) fillet.
It is not necessary to weld inside the large holes.
139. Remove all slag and splatter. Clean and de-grease
all bare and discolored areas. Paint green.
140. Re-mount the removed wheel.
Install Right Anchor
141. Repeat step 132 through step 140 for the right side.
Figure 39
Pull Bar Anchor Installed
Q0112
923
923
923
7
8
Figure 40
Pull Bar Anchors (from below)
32126
923
923
7
8