Bio-Rad Microplate Manager Software - Manual (Page 20)

Microplate Manager User Guide
10
When you open a protocol, Microplate Manager will look first for a reader at the
serial port you select. If a reader is not found at that port, the software will scan the
remaining ports as well as the SCSI bus for a reader.
If a reader is found at a particular port, that port will be selected. If no reader is found
at any serial port or the SCSI port, you will receive an error message.
2.7 Setting Filters
If you change the filters in the Ultramark or Model 550 microplate readers, you can
specify the wavelengths of the new filters from within Microplate Manager.
(Benchmark users should refer to the hardware manual for instructions on changing
filter settings.)
2.7.1 Ultramark Setup
Select Ultramark Setup from the OPTIONS menu
Figure 4. Ultramark Setup dialog box.
For each filter, enter the appropriate wavelength. The wavelengths of the filters that
are shipped with the Ultramark will be included with your Ultramark documentation.
If you change any of the filters, you will need to change these settings.