Bio-Rad Microplate Manager Software - Manual (Page 66)

Microplate Manager User Guide
56
before the reports have been generated, you will be prompted for the labeling
information if it has not already been entered.
For example, if the labels “Date” and “Operator” are created in a protocol file, then
when that protocol is run, a dialog box will pop up after plate reading prompting you
to type the date and the operator’s name. Both the label (e.g., Date) and the label
contents (e.g., July 4, 1999) are printed on the report.
In the Reports dialog box, click on Labels... to open the Define Labels dialog box.
Figure 39. Define Labels dialog box.
See section 6.6.1 for information about defining labels.
After you have defined your labels, you can fill them in by clicking on the Fill
Labels... button in the Reports dialog box.
See section 6.6.1 for information about filling in labels.
½
You can also define and fill out labels after the protocol has been run, when the
data is displayed (see section 6.6.1). Labels created after a protocol has been run
cannot be saved with the protocol.